The Pagolux® expanded metal ceiling PagoScrew consists of expanded metal plates ceiling support / stabilization profiles and mounting clamps with drilling screws.
elo. verz. steel or aluminum
75 x 35 x 3 x 2mm or 62 x 32 x 3 x 2mm
Widths up to approx. 1250 mm, lengths up to approx. 2500 mm
Fire protection class:
A2-s1, d0, DIN EN 13501-1
Expanded metal plates with closed meshes all around and minimal joint for bolting to CD profiles using the system’s own mounting clamp
A counter grid consisting of ceiling support and stabilization profiles, longitudinal connectors and combi connectors with vernier hangers must be suspended from the bare floor at the statically required distance using approved dowels, screws, etc. and aligned plumb and true.
The maximum distance of the support profile must not exceed 1250 mm and depends on the width of the board.
The expanded metal panels must then be screwed to the ceiling support profiles using the system’s own mounting clamps.
The maximum distance between the mounting clamps is 200 mm. In the joint area of two expanded metal sheets, these are to be placed on the CD profile so that a joint of 1-5 mm results.
The expanded metal blanks are made of elo. galvanized steel and end on full mesh.
Therefore, the blank length should be selected so that it is divisible by the mesh width.
The same applies to the blank width and the mesh length
We will be happy to advise you individually based on your object.
Care and cleaning instructions:
Pagolux®-Streckmetalldecken sind wie folgt zu reinigen:
Clean surfaces with slightly damp cloth and then dry with soft cloth.
- Use only pure water, if necessary with small additions of neutral or weakly alkaline detergents.
- Use only soft, non-abrasive cloths.
- Do not use steam jets or high-pressure cleaners.
- Do not use scratching, abrasive agents.
- Avoid vigorous rubbing.
- Always carry out preliminary tests on non-visible surfaces before cleaning.