The insertion grid has proven itself for a wide variety of installation options. It can be used both flat and in partial areas for backlighting or ventilation.
Contour Grid FA
25 mm / 30 mm / 40 mm (depending on module)
Axle 600 x 1200 mm: 30, 40, 50 mm
Axle 625 x 1250 mm: 31.25, 62.5 mm
Coil-lacquered with blank cut edges / optionally additionally powder-coated
Fire protection class:
A2-s1, d0, DIN EN 13501-1
Insertion grid, consisting of a substructure made of PA25 profiles and prefabricated, fold-down grid elements
A counter grating consisting of grating angles, system-specific PA25 profiles and corresponding connectors with vernier hangers or threaded rods must be suspended from the raw ceiling at the statically required distance of 1200 mm using approved dowels, screws, etc. and aligned plumb and true.
The PA25 profile with shaped perforations is screwed under the grating angle to match the longitudinal axis of the grating elements. The grid elements are then fitted with four mounting springs and clipped into the PA25 support profile via these.
The individual grid elements are self-adjusting and can be folded down individually. Correct alignment is ensured by punched holes in the grid element and the PA25 profile.
The edge connection is optionally made as an open shadow gap, via an L-edge angle or a system-compliant C-profile.
- narrow fine bridges
- Many possible uses
- neutral and timeless
- Easy to revise, as it can be folded down
We will be happy to advise you individually based on your object.
Care and cleaning instructions:
Pagolux®-Rasterdecken sind wie folgt zu reinigen:
Clean surfaces with slightly damp cloth and then dry with soft cloth.
- Use only pure water, if necessary with small additions of neutral or weakly alkaline detergents.
- Use only soft, non-abrasive cloths.
- Do not use steam jets or high-pressure cleaners.
- Do not use scratching, abrasive agents.
- Avoid vigorous rubbing.
- Always carry out preliminary tests on non-visible surfaces before cleaning.